Table of Contents
Advertisement
6.3 The TIME Mode
Figure 6-5 shows the overall block diagram of the TIME Mode in the
RUNNING Display Mode.
STOPPED
DISPLAY
MODE
(Forced Stop)
In the TIME Mode, you pump fluid at a certain motor speed or flow rate, for a
particular amount of time. The pump motor uses the RPM or FLOW RATE
setting. It measures the volume of fluid dispensed, but ignores the TOTAL
VOLUME setting.
6.3.1 Pumping in the TIME Mode
To pump fluid in the TIME Mode, do the following:
1.
2.
3.
Operating the Pump Motor in the RUNNING Display Mode
CURRENT
TUBE ID
TUBE ID
SETTING
CURRENT
FLOW
FLOW RATE
RATE
SETTING
CURRENT
RPM
RPM
SETTING
CURRENT
TIME
TIME SETTING
(Time Runs Out)
TIME ELAPSED
START
DURING PUMPING
STOP
Figure 6-5. Block Diagram: Pumping in the TIME Mode
Set up the pump motor for pumping according to Chapter 3.
Toggle the ON/OFF switch to turn on the unit's power. The display is in the
STOPPED Display Mode. Refer to Figure 6-5.
Using the procedure outlined in Sections 6.1.1. and 6.2.1, adjust either the
RPM or FLOW RATE setting.
TUBE ID SETTING
TO BE USED IN
OR
PUMPING
(Refer to Section 5.5)
FLOW RATE
SETTING
OR
TO BE USED IN
PUMPING
(Refer to Section 5.5)
RPM SETTING TO BE
USED IN PUMPING
OR
TIME SETTING
TIME
TO BE USED IN
PUMPING
and
OR
RUNNING
START
DISPLAY
STOP
MODE
CALIBRATE
(Optional)
CALIBRATE
(Optional)
6
6-11
Advertisement
Table of Contents
