Abs Disable - Thruxton And Thruxton R Models Only - Triumph T120 Owner's Manual

ABS Disable - Thruxton and
Thruxton R Models Only
It is possible to temporarily disable the
ABS system. The ABS system cannot be
permanently disabled, it will be enabled
when the ignition is turned off and then
on again.
Warning
Do not attempt to adjust the ABS
settings while the motorcycle is in
motion as this may lead to loss of
motorcycle control and an accident.
Warning
If the ABS is disabled, the brake system
will function as a non-ABS braking
system. In this situation braking too
hard will cause the wheels to lock, and
may result in loss of motorcycle
control and an accident.
To Disable the ABS
To access the ABS disable function:
Make sure the motorcycle is stationary
and in neutral. Turn the ignition to the
ON position and put the engine start/
stop switch in the RUN position.
Press and release the SCROLL button
until 'AbSOn' is shown in the left hand
display.
Press and hold the SCROLL button for
one second to change between ABS on
and ABS off.
General information
Note:
• With the ABS disabled, the traction
control will still function (unless
traction control has been manually
disabled).
1. ABS control off display
To Enable the ABS
To enable the ABS system again, repeat
the ABS disable procedure and select
ABS on.
An alternative way to enable the ABS is
to turn the ignition OFF and ON.
1
39