Table of Contents
Advertisement
Problem solving guide
Downloaded from CoffeeMachineManual.com Manuals
74
^ If this fault message continues to appear, please call the
Miele Service Department.
. . . the machine does not rinse through when switched on,
even though the Automatic rinsing programme is set to
"On".
If the temperature of the machine is still above 60 °C, rinsing
cannot take place.
. . . water stopped flowing whilst programming in the
amount to use.
Water flow stops automatically when the maximum fill quantity
is reached. The maximum quantity is stored in memory.
There is insufficient water in the water container. The quantity
used previously was not saved to memory.
. . . there is water in the waste container.
This is not a fault. The water is left over from the brewing and
cleaning process.
. . . there is a lot of residual "coffee water" in the waste
container.
If the slide control for the grinder is set to very fine, too much
residual "coffee water" can be left in the waste container.
^ If a very fine grinder setting has not been set, call the Miele
Service Department.
. . . the descaling process was started by mistake.
The descaling programme cannot be cancelled once you
have pressed the right hand control. The programme has to
be completed through to the end. This is a safety measure to
ensure that the machine is fully descaled, and is important to
protect the machine and ensure it functions correctly.
. . . the heating-up time is getting longer, the amount of
water coming through is incorrect and the machine is not
performing properly.
The machine needs descaling.
Hide quick links:
Advertisement
Table of Contents
