Page 1
Installation instructions CVA4062 en-CA Installation, repair and maintenance work should be performed by a Miele authorized service technician in accordance with national and local safety regulations and the provided installation instructions.
If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or contact Miele’s Technical Service Department. See back page for contact information. WARNING: THIS APPLIANCE MUST BE...
Miele appliances can be installed flush or proud. Discuss your installation requirements with your architect, designer and installer. A combination with other Miele built in appliances is possible. If the machine is installed in combination with other appliances, it should be installed with a protective base between the appliance and the unit (exception: installation with a built-in plate warmer).
Page 4
Installation Installation ^ If your cabinet has 3/4" (19 mm) side walls, drill four holes for the Make sure power is not supplied to mounting. the appliance while installation or ^ Center the unit and turn the screws a maintenance work is performed. little bit in and then out again.
Page 5
Installation Adjusting the door hinges The door hinges can be adjusted if the door cannot be opened easily. ^ To adjust the door sideways, a, turn screw a. ^ To adjust the door to the front or back, b, turn screw b.
Page 6
'virtual link' between your following requirements appliance and our monitoring center. If – A wireless router that supports an a fault occurs, Miele's client service IEEE 802.11b protocol center will be notified and contact you, ® or another trusted individual identified –...
Page 7
Alteration rights reserved / 1409 M.-Nr. 07 611 180 / 00 CVA 4062, CVA 4068 For the most updated manual please see the Miele web site.