Installation Instructions CVA 4062 en-CA Installation, repair and maintenance work should be performed by a Miele authorized service technician in accordance with national and local safety regulations and the provided installation instructions.
IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances basic safety precautions should always be followed, including the following: Read all instructions before installation or use of the coffee system. Proper use Please read these instructions This coffee system is for household carefully to prevent accidents and use only, for the preparation of coffee machine damage.
Do not use an extension cord to connect the appliance to electricity. Defective components should be Extension cords do not guarantee the replaced by Miele original spare parts required safety of the appliance only. Only with these parts can the (danger of overheating and open manufacturer guarantee the safety of ground circuit).
Contact Caution! Risk of burns when Miele. dispensing hot beverages, they are extremely hot. Always attach the cord to the appliance first, then plug it into the wall Before the first use, flush the supply outlet.
Never place a cup with an Only use the descaling tablets alcohol-coffee mixture underneath the provided by Miele. Take care to use the main dispenser. Plastic parts of the unit correct mixture of water and descaler, could catch fire! otherwise it may cause damage.
If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or contact Miele’s Technical Service Department. See back page for contact information.
Miele appliances can be installed flush or proud. Discuss your installation requirements with your architect, designer and installer. A combination with other Miele built in appliances is possible. If the machine is installed in combination with other appliances, it should be installed with a protective base between the appliance and the unit (exception: installation with a built-in plate warmer).
^ Plug the appliance into the electrical outlet. ^ If there is no sealing strip around the installation recess, stick the Miele sealing strip onto the appliance from the back before putting it into the recess. Sealing strips are available...
Installation Adjusting the door hinges The door hinges can be adjusted if the door cannot be opened easily. ^ Push the appliance into the niche. ^ Open the door and partially tighten ^ To adjust the door sideways, a, turn the screws.
Alteration rights reserved / 0710 M.-Nr. 07 816 880 / 00 CVA 4062, CVA 4068 INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.