Depth & Contour Options - Raymarine a65 Operation Instructions Manual

14.21 Depth & Contour options
If supported by your cartography type, the following depth and contour settings are available.
Note: The table below identifies the Depth & Contour options supported by each cartography vendor,
however the option may not be supported by all levels of cartography supplied by that vendor. Please
check with your cartography vendor for supported features.
Menu item Description
High Res Bathy Determines whether Jeppesen's High
Resolution Bathymetry Value Added Data
(VAD) is displayed.
Show Soundings Determines the depth at which depth
soundings are displayed.
Show Contours Determines whether contours are displayed.
Shallow Water Determines the depth at which the Shallow
contour is displayed.
The Shallow contour cannot be set to a value
greater than the Safety or Deep contours.
Safe Water From Determines the depth at which the Safety
contour is displayed.
The Safety contour cannot be set to a value
less than the Shallow contour or higher than
the Deep contour.
Deep Water From Determines the depth at which the Deep
contour is displayed.
The Deep contour cannot be set to a value
less than the Shallow or Safety contours.
Deep Water Color Determines whether Deep Water is colored
Blue or White.
Sonar Logs Allows logging of depth and position data
to your Navionics chart card. This data will
be sent to Navionics to improve the contour
detail of Sonar Charts on your multifunction
display. Refer to the Navionics website
www.navionics.com
upload your sonar logs.
Depth soundings and contours
If supported by your cartography type, depth
soundings and contours can be used in the Chart
application to provide awareness of water depth.
When using vector based cartography you can adjust
the depth at which the contours and soundings
appear on-screen.
188
Note:
• VAD is available at an additional cost
from Jeppesen.
• VAD may not be available in all areas.
for instructions on how to
LightHouse
1. Shallow Water
2. Safe Water From
3. Deep Water From
The Depth & Contours menu can be accessed from:
Menu > Presentation > Depth & Contours.
Navionics ® Jeppesen
1 2
LightHouse MFD operation instructions
®
3
D13009-1