Lenovo ThinkServer TD340 Operating System Installation Manual page 51

7. In the INSTALLATION SUMMARY window, click INSTALLATION DESTINATION.
8. Select the drive partition on which you want to install the operating system. Then, click Done. If you
want to create a partition manually, do the following:
a. Select I will configure partitioning and then click Done.
b. In the Manual Partitioning window, select a partitioning scheme (select Standard Partition in the
UEFI mode). Then, do one of the following to create a partition and click Done.
• Manually create a root partition (/)
To create a root partition, do the following:
1) In the Manual Partitioning window, click + in the bottom left corner.
2) In the ADD A NEW MOUNT POINT window, select the forward slash (/) from the Mount
Point drop-down list box.
3) Type the amount of space (in MB) in the Desired Capacity field and then click Add mount
point.
• Manually create a boot partition (/boot)
To create a boot partition, do the following:
1) In the Manual Partitioning window, click + in the bottom left corner.
2) In the ADD A NEW MOUNT POINT window, select /boot (or /boot/efi in the UEFI mode)
from the Mount Point drop-down list box.
3) Type the amount of space (in MB) in the Desired Capacity field and then click Add mount
point.
• Manually create a swap partition
To create a swap partition, do the following:
1) In the Manual Partitioning window, click + in the bottom left corner.
2) In the ADD A NEW MOUNT POINT window, select swap from the Mount Point drop-down
list box.
3) Type the amount of space (in MB) in the Desired Capacity field and then click Add mount
point.
c. In the SUMMARY OF CHANGES window, select Accept Changes.
9. In the INSTALLATION SUMMARY window, click Begin Installation. The installation process begins.
10. In the CONFIGURATION window, click ROOT PASSWORD to set the root password. Then, click
Reboot.
11. In the INITIAL SETUP window, click LICENSE INFORMATION.
12. In the LICENSE INFORMATION window, select I accept the license agreement and click Done.
13. In the INITIAL SETUP window, click Finish Configuration.
14. In the Kdump window, click Forward.
15. In the "Subscription Management Registration" window, select No, I prefer to register at a later
time and click Finish.
16. Configure the language and click Next ➙ Next.
17. Set your user name and the password (if needed) and click Next.
18. Select the location and click Next.
19. Select Start using Red Hat Enterprise Linux Server to log in to the operating system.
Note: The local account is used by default when logging in to the operating system for the first time.
Log out and then log in to Root.
.
Chapter 2 Installing an operating system in legacy mode
45