Deactivation; Resume Speed; Varying The Speed - Jeep Renegade 2015 Owner's Manual

340 STARTING AND OPERATING
When the vehicle has reached the desired speed, push the
SET (+) or SET (-) button and release. Release the
accelerator and the vehicle will operate at the selected
speed.

Deactivation

A soft tap on the brake pedal, pushing the CANCEL
button, or normal brake pressure while slowing the
vehicle will deactivate the Electronic Speed Control with-
out erasing the set speed from memory.
Pushing the ON/OFF button or turning the ignition
switch OFF erases the set speed from memory.

Resume Speed

To resume a previously set speed, push the RES button
and release. Resume can be used at any speed above
20 mph (32 km/h).

Varying The Speed

To Increase Speed
When the Electronic Speed Control is set, you can in-
crease speed by pushing the SET + button.
The drivers preferred units can be selected through the
Uconnect® system if equipped. Refer to "Uconnect®
Settings" in Multimedia" for more information. The
speed increment shown is dependant on the chosen
speed unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
• Pushing the SET + button once will result in a 1 mph
increase in set speed. Each subsequent tap of the
button results in an increase of 1 mph.
• If the button is continually pushed, the set speed will
continue to increase until the button is released, then
the new set speed will be established.