Jeep Renegade 2015 Owner's Manual page 598

596 MULTIMEDIA
• LaneSense Strength — If Equipped
When this feature is selected, it sets the strength of the
steering wheel feedback for potential lane departures.
The amount of directional torque the steering system can
apply to the steering wheel to correct for vehicle lane
departure can be set at "Low," "Medium" or "High."
For further information, refer to "Lane Departure Warn-
ing (LDW)" in "Starting and Operating."
• Blind Spot Alert — If Equipped
When this feature is selected, the Blind Spot Alert feature
can be set to Off, Lights or Lights and Chime. The Blind
Spot Alert feature can be activated in Lights mode. When
this mode is selected, the Blind Spot Monitor (BSM)
system is activated and will only show a visual alert in
the outside mirrors. When Lights & Chime mode is
activated, the Blind Spot Monitor (BSM) will show a
visual alert in the outside mirrors as well as an audible
alert when the turn signal is on. When Off is selected, the
Blind Spot Monitor (BSM) system is deactivated. To
change the Blind Spot Alert status, press the "Off,"
"Lights" or "Lights & Chime" button on the touchscreen.
Then press the back arrow button on the touchscreen.
NOTE: If your vehicle has experienced any damage in
the area where the sensor is located, even if the fascia is
not damaged, the sensor may have become misaligned.
Take your vehicle to an authorized dealer to verify sensor
alignment. A sensor that is misaligned will result in the
BSM not operating to specification.
• Hill Start Assist — If Equipped
When this feature is selected, the Hill Start Assist (HSA)
system is active. Refer to "Electronic Brake Control
System" in "Safety" for system function and operating
information. To make your selection, press the "Hill Start
Assist" button on the touchscreen and make your selec-
tion. Press the back arrow button on the touchscreen to
return to the previous menu.