Led Description - HP MSR2000 Series Manual

LED description

LEDs
SYS
PWR
PoE
CF card LED
VPM
USB console
port LED
Console port
LED
GE
SFP
State
Flashing green (8 Hz)
Steady green
Flashing green (1 Hz)
Flashing yellow (1 Hz)
Flashing yellow (8 Hz)
Steady yellow
Off
Steady green
Off
Steady green
Steady yellow
Off
Steady green
Flashing green
Steady yellow
Off
Steady green
Steady yellow
Off
Steady on
Off
Steady on
Off
Steady green
Flashing green
Steady yellow
Flashing yellow
Off
Steady green
Flashing green
Steady yellow
Description
The BootWare runs.
The SDRAM is performing self-test.
Comware has started with the configuration file and the router
has booted up.
The DDR3 SDRAM has failed the self-test.
The extended segment does not exist.
The boot image does not exist.
No power input, or exceptions have occurred.
The power supply is operating properly.
No power input.
The power supply is operating properly.
The internal power supply for at least one PoE has failed or no
power supply for the PoE port.
No power input.
An inserted CF card has passed the detection.
The system is accessing the CF card. The CF card cannot be
removed.
An inserted CF card did not pass the detection.
No CF card is inserted or the inserted CF card cannot be
identified.
An inserted VPM has passed the detection.
An inserted VPM did not pass the detection.
No VPM in the slot.
The router is using the USB console port for configuration.
The router is not using the USB console port.
The router is using the console port for configuration.
The router is not using the console port.
A 1000 Mbps link is present.
Data is being received or transmitted at 1000 Mbps.
A 10/100 Mbps link is present.
Data is being received or transmitted at 10/100 Mbps.
No link is present.
A link is present on the SFP interface.
Data is being transmitted or received on the SFP interface.
The SFP transceiver didn't pass the detection.
iv