HP J2600A Installation Manual page 13

Installation
Installation Summary
f. Place the SNMP module, component-side down, on top of the
router module, with the male connector on the SNMP module
(behind the white extractor handle) mating with the female
connector on the router module.
g. Press the two connectors together, then insert and tighten the
supplied screws through the holes in the SNMP module into the
standoffs mounted on the router module.
h. Install the assembled router and SNMP modules, with the SNMP
module below, into the hub's Expansion Slot
i. Install the new cover plate provided with the router module over
the Expansion Slot.
j. Install the two hex nut screws supplied with the router module
into the holes alongside the WAN port connector, then tighten
them using the supplied nutdriver.
For details about this procedure (including illustrations), refer to
page 1-10.
4. Connect the WAN Cable. For details, refer to page 1-16.
5. Connect a Console. If the router is to be configured, verified,
and/or managed from a PC running HP Stack Manager, connect the
serial port of the PC to the hub's RS-232 Distributed Management
port, and install the software on the PC. For details, refer to page
1-18.
6. Verify the Router Module Starts Up Properly.
a. Connect the hub to the power source.
b. Check that the Router Self-test LED on the router's cover plate
turns on (for about 30–60 seconds) and then off.
c. In HP Stack Manager, click on the Connect button.
d. Highlight the hub in the Device Chain List, then press and hold
down the Shift key while you click on the Access button.
e. Check that the Copyright and Main Menu screens appear.
For details about this procedure, refer to page 1-20.
1-3