Led Description - HP MSR930 3G Instructions Manual

Figure 42 Rear panel LEDs
(1) GE port status LED (yellow)
(3) Serial port data receiving status LED (ACT)

LED description

LED Location
SYS Front panel
INTERNET Front panel
VPN Front panel
WWAN Front panel
RSSI Front panel
(2) GE port status LED (green)
(4) Serial port link status LED (LINK)
Status Description
No power input, or exceptions have occurred on the
Off
MPU.
The SDRAM is performing self-test.
Steady green
The system software image is being copied and
Flashing green
decompressed.
(8 Hz)
Flashing green Comware has started with the configuration file and
(1 Hz) the router has booted up.
Flashing yellow
The SDRAM has failed the self-test.
(1 Hz)
Flashing yellow
The extended segment does not exist.
(8 Hz)
Steady yellow The system software image does not exist.
Off The router has not been connected to the network.
Steady on The router has been connected to the network.
Off A VPN link is present.
Steady on No VPN link is present.
Off No link is present or no 3G network is available.
The router has been connected to the wireless
Steady green
network and is operating in 3G mode.
Flashing green Data is being received or transmitted. The router is
(8 Hz) operating in 3G mode.
The router has been connected to the wireless
Steady yellow
network and is operating in 2G mode.
Flashing yellow Data is being received or transmitted. The router is
(8 Hz) operating in 2G mode.
Off Weak or no signal.
36