HP J2600A Installation Manual page 50

Installation
4. Verify the Network Links.
RGETD: Use the Rgetd command to display the DECnet router
configuration table. Verify that all DECnet circuit groups are
available.
RGETDN: Use the Rgetdn command to display the DECnet router
level 1 (intra-area) routing table for a local or remote HP router.
Verify that the router has learned about all routers and end nodes in
its area. Also, trace the paths to the destination nodes to verify that
the hop counts and path costs are as expected.
RGETDA: Displays the DECnet router level 2 (inter-area) routing
table for a local or remote router. Verify that the router has learned
about a path to all areas. Trace the paths to the level 2 router in the
destination area to verify that hop counts and path costs are as
expected. Note that DECnet routing services on HP routers are
always level 1 and level 2 routing services, but this may not be true
for DECnet routing services from other vendors.
RGETATR: Displays the AppleTalk routing table. Verify that network
range entries exist for all AppleTalk networks. The network ranges
should be consistent with those recorded on the network map.
Check the next hop entries to determine the route that AppleTalk
packets will take to each destination network. Verify that the
number of hops to these subnets is what you expect. Check the
status field to verify that there are no entries that are marked
suspect or bad.
2-17