Using The Magnify Feature - Hitachi CP-WU5500 User Manual

Using the magnify feature

1.
Press the MAGNIFY ON button on the remote
control.
The picture will be magnified, and the MAGNIFY
dialog will appear on the screen. When the
MAGNIFY ON button is pressed for the first time
after the projector is turned on, the picture will be
zoomed by 1.5 times. On the dialog, triangle marks
to show each direction will be displayed.
2.
The display magnification of the projector switches in order
with every press of the MAGNIFY ON button.
 For computer signals, HDMI
input signals from the LAN port
1.5 times  2 times  3 times  4 times  1 time
 For video signals, HDBaseT signals, MHL signals or HDMI
1.5 times  2 times  1 time
3.
While the triangles are displayed on the dialog, use the ▲/▼/◄/► cursor
buttons to shift the magnifying area.
4.
Press the MAGNIFY OFF button on the remote control to exit magnification.
NOTE
• The MAGNIFY dialog will automatically disappear in several seconds
with no operation. The dialog will appear again if the MAGNIFY ON button is
pressed when the dialog has automatically disappeared.
• The magnification is automatically disabled when the displaying signal or its
display condition is changed.
• While the magnification is active, the keystone distortion condition may vary. It
will be restored when the magnification is disabled.
• Some horizontal stripes might be visible on the image while magnification is
active.
• This function is not available in the following cases:
- A sync signal in the range not supported is input.
- There is no input signal.
(RGB) signals, HDBaseT
TM
Operating
MYBUTTON
INPUT
1 2
ASPECT PbyP AUTO
MAGNIFY FOCUS ZOOM
+
ON MAGNIFY
MYBUTTON
INPUT
1 2
ASPECT PbyP AUTO FREEZE
ON/OFF
MAGNIFY FOCUS ZOOM VOLUME
ON + + +
OFF - - -
PAGE
button
UP GEOMETRY PICTURE MUTE
OFF
-
DOWN INTERACTIVE NETWORK BLANK
ESC MENU
ENTER
PAGE
OSD MSG RESET
UP GEOMETRY PICTURE
INTERACTIVE NETWORK
DOWN
ESC
ENTER
signals,
TM
OSD MSG
signals
TM
FREEZE
VOLUME
+ +
- -
MUTE
BLANK
MENU
RESET
45