Hitachi CP-WU5500 User Manual page 90

OPTION menu
Item
SERVICE
(continued)
(continued on next page)
90
Selecting this item displays COMMUNICATION
menu.
In this menu, you can configure the serial
communication settings of the projector using the
CONTROL port.
• Select an item using the cursor buttons ▲/▼.
Then pressing the ► button opens the submenu
for the setting item you selected. Or, pressing
the ◄ button instead of the ► button makes the
menu back to the previous one without changing
the setup. Each submenu can be operated as
described above.
• When COMMUNICATION TYPE (below) is
set to OFF, the other items except STACK in
COMMUNICATION menu are invalid.
• For the function of serial communication, refer to
the Network Guide.
COMMUNICATION TYPE
COMMUNICATION
Select the communication type for transmission via
the CONTROL port.
NETWORK BRIDGE: Select this type, if it is
OFF: Select this mode to receive RS-232C
• OFF is selected as the default setting.
• When you select the NETWORK BRIDGE, check
the item, TRANSMISSION METHOD (91).
・When NETWORK BRIDGE is selected, RS-232C
menu of CONTROL TERMINAL cannot be set. The
setting of RS-232C is forcibly set to CONTROL.
Description
NETWORK BRIDGE (WIRELESS)

NETWORK BRIDGE (WIRED)

OFF
required to control an external device as a
network terminal, via this projector from the
computer. Select WIRELESS or WIRED as your
network connection mode.
The CONTROL port does not accept RS-232C
commands (7. Network Bridge Function in
the Network Guide).
commands using the CONTROL port.