Replacing The Internal Clock Battery - Hitachi CP-WU5500 User Manual

Replacing the internal clock battery

Installing the battery is required in some cases. (
User's Manual - Network Guide) A battery is not contained at the time of factory
shipment. Please replace a battery according to the following procedure.
1.
Turn the projector off, and unplug the power cord. Allow the
projector to cool suffi ciently.
2.
After making sure that the projector has cooled adequately,
slowly turn over the projector, so that the bottom is facing.
3.
Turn the battery cover fully in the direction indicated "OPEN"
using a coin or the like, and pick the cover up to
remove it.
4.
Pry up the battery using a fl athead screwdriver or the like
to take it out. Do not use any metal tools.
While prying it up, put a fi nger lightly on the battery since it
may pop out of the holder.
5.
Replace the battery with a new HITACHI MAXELL,
Part No.CR2032 or CR2032H.
Slide the battery in under the plastic claw, and push it
into the holder until it clicks.
6.
Replace the battery cover in place, then turn it in the
direction indicated "CLOSE" using such as coins, to fi x.
WARNING ►Always handle the batteries with care and use them only as
directed. Battery may explode if mistreated. Do not recharge, disassemble or
dispose of in fi re.
And also improper use may result in cracking or leakage, which could result in
fi re, injury and/or pollution of the surrounding environment.
・ Be sure to use only the batteries specifi ed.
・ Make sure the plus and minus terminals are correctly aligned when loading a battery.
・ Keep a battery away from children and pets. If swallowed consult a physician
immediately for emergency treatment.
・ Do not short circuit or solder a battery.
・ Do not allow a battery in a fi re or water. Keep batteries in a dark, cool and dry place.
・ If you observe battery leakage, wipe out the leakage and then replace a battery. If the
leakage adheres to your body or clothes, rinse well with water immediately.
・ Obey the local laws on disposing a battery.
Event Scheduling in the

Battery Cover
90°
Maintenance
OPEN
CLOSE
90°
107