Correcting The Keystone Distortions; Using The Magnify Feature - Hitachi CP-X300 User Manual

Operating

Correcting the keystone distortions

1.
Press KEYSTONE button on the remote control. A dialog will
appear on the screen to aid you in correcting the distortion.
2.
Use the ▲/▼ cursor buttons to select AUTO or MANUAL
operation, and press the ► button to perform the following.
(1) AUTO executes automatic vertical keystone correction.
(2) MANUAL displays a dialog for keystone correction.
Use the ▲/▼ buttons for adjustment.
To close the dialog and complete this operation, press
KEYSTONE button again. Even if you do not do anything, the
dialog will automatically disappear after a few seconds.
● The adjustable range of this correction will vary among inputs. For some input,
this function may not work well.
● When V:INVERT or H&V:INVERT is selected for MIRROR item in SETUP
menu, if the projector screen is inclined or angled downward, this function may
not work correctly.
● When the zoom adjustment is set to TELE (telephoto focus), the automatic keystone
distortion correction may be excessive. This function should be used when the zoom
adjustment is set to the full WIDE (wide-angle focus) whenever possible.
● When the projector is placed on the level (about ±0°), the automatic keystone
distortion correction may not work.
● When the projector is inclined to near ±30 degree or over, this function may not work well.
● This function will be unavailable when Transition Detector is on (49).

Using the magnify feature

1.
Press the ON button of MAGNIFY on the remote control.
The "MAGNIFY" indication will appear on the screen and the
projector will go into the MAGNIFY mode. The indication will
disappear in several seconds with no operation.
2.
Use the ▲/▼ cursor buttons to adjust the zoom level.
To move the zoom area, press POSITION button in the MAGNIFY
mode, then use the ▲/▼/◄/► cursor buttons to move the area. And to
finalize the zoom area, press POSITION button again.
To exit from the MAGNIFY mode and restore the screen to normal,
press the OFF button of MAGNIFY on the remote control.
● The projector automatically exits from the MAGNIFY mode when the input
signal is changed or when the display condition is changed.
● In the MAGNIFY mode, the keystone distortion condition may vary, it will be
restored when the projector exits from the MAGNIFY mode.
NOTE • The zoom level can be finely adjusted. Closely watch the screen to
find the level you want.
0
KEYSTONE
COMPUTER
VIDEO SEARCH
ASPECT AUTO BLANK
MAGNIFY
HOME PAGE UP VOLUME
ON
PAGE DOWN MUTE
END
OFF
FREEZE MY BUTTON KEYSTONE
1 2
MENU
POSITION
ENTER
ESC RESET
MAGNIFY
ON/OFF
COMPUTER
VIDEO SEARCH
ASPECT AUTO BLANK
MAGNIFY
HOME PAGE UP VOLUME
ON
PAGE DOWN MUTE
END
OFF
FREEZE MY BUTTON KEYSTONE
1 2
MENU
POSITION
ENTER
ESC RESET