Installing Or Replacing The Internal Clock Battery - Hitachi MP-AW4001 User Manual

Installing or replacing the internal clock battery

This product has an internal clock. When you use the function that requires the
internal clock (
If the internal clock starts to malfunction, try to replace the battery.
Use the following type of battery, and follow the steps below.
1.
Turn the projector off, and unplug the power cord.
Turn the battery cover fully counterclockwise using a
2.
coin or the like, and pick the cover up to remove it.
3.
or the like to take it out. Do not use any metal tools.
since it may pop out of the holder.
4. Install a new battery in place.
Slide the battery in under the plastic claw, and push
it into the holder until it clicks.
5.
Replace the battery cover in place, then turn it
clockwise
WARNING
And also improper use may result in cracking or leakage, which could result in
• Make sure the plus and minus terminals are correctly aligned when loading a
battery.
• Keep a battery away from children and pets. If swallowed, consult a physician
immediately for emergency treatment.
• Do not short circuit or solder a battery.
place.
• If you observe battery leakage, wipe out the leakage and then replace a battery.
If the leakage adheres to your body or clothes, rinse well with water immediately.
• Obey the local laws on disposing a battery.
16
"Event Scheduling" in the Network Guide), install a new battery.
CR2032 or CR2032H
90°
90°