Honeywell Performance HED1PR3 Software Configuration Manual page 59

Table 5-7 TCI/IP Configuration
Parameter Function
IP Version Select the IP version you are using: IPv4 or IPv6.
If Static mode is selected, type values for the IP Address, Subnet
IP Address
mask, and Default Gateway.
Preferred DNS Enter the preferred DNS server IP address.
Server
Alternate DNS Enter an alternate DNS server IP address.
Server
If you know the camera's MAC address, then use the ARP/Ping
command to modify or set the camera's IP address.
Before operating the camera, please ensure that the network
camera and the PC are in the same LAN. This function is On by
default.
To enable ARP/Ping to set the IP address service:
1. Get an IP address. Set up the network camera and the PC in the
same LAN.
2. Get the physical address from the label on the network camera.
3. Open the Run interface (Start menu > Run), and then type the
Enable ARP/Ping
following commands:
to set IP Address
arp -s <IP Address> <MAC>
Service
ping -l 480 -t <IP Address>
For example:
arp -s 192.168.0.125 11-40-8c-18-10-11
ping -l 480 -t 192.168.0.125
4. Reboot the camera. If the setup was successful, output
information such as Reply from 192.168.0.125... will
appear in the command output lines.
5. Close the command line.
6. Open your browser, type http://<IP address> in the address
bar, and then press Enter.
Configuring Camera Settings | 59
800-21358 - A - 10/2015