Understanding The Beeps; Stacked Code Crackle - Intermec SR61T1D User Manual

Chapter 2 — Scanning With the SR61T

Understanding the Beeps

Stacked Code Crackle

14
The SR61T beeps to give you audio feedback when performing some
functions. For example, you hear a beep each time you scan a valid bar
code. The beeps described in this section are new and do not
correspond to the legacy SR61T models (SR61TV, SR61TA, SR61TL
or SR61TE).
Note: If you prefer to use the legacy beep and LED mode you can
activate the legacy mode using EasySet. For information on using
EasySet see Chapter 4, "Configuring the SR61T" on page
Default SR61T Beep Descriptions
Beep Sequence
Two beeps
Single beep
Two fast beeps
Six very fast beeps Transmission error
When using SR61TL (laser scanner) by default the scanner makes a
crackle noise when reading stacked codes (such as PDF417). For more
information see EasySet.
Note: You can modify many of the default settings for the light, beeps
and crackle using EasySet version 5.6.4.0 or higher. EasySet is available
on the Intermec web site at
What it Means
Power-up
The scanner successfully scanned a bar code.
Configuration bar code successfully scanned
OR
Configuration bar code was not accepted
www.intermec.com/EasySet.
SR61T Tethered Scanner User's Guide
31.