Beeps And Vibrate Alert - Intermec SF61BUG User Manual

Beeps and Vibrate Alert

SF61 Cordless Scanner User's Guide
Default Status Light Description When the Scanner is Docked in a
Charger
Light State
Red continuously on
and 6 fast beeps every
2 seconds
Amber blinking
Note: The following table shows the default behavior of the beeps and
vibrate alert, you can use EasySet to modify many of these settings if
you wish (Operating settings > Beeps / LEDs).
The SF61B beeps to give you audio feedback and vibrates when
performing some functions. For example, you hear a beep each time
you scan a valid bar code.
Default SF61B Beep and Vibrate Alert Descriptions
Beep Sequence
Single beep and
vibrate alert
Two fast beeps and
vibrate alert
Chapter 1 — Introducing the SF61B Cordless Scanner
What it Means
NVM (non-volatile memory) problem.
Battery charging problem:
•
battery failure
Solution: Replace the battery.
•
temperature problem: the integrated charge
handler in the SF61B refuses to charge the battery
due to storage or use of the SF61B and/or the
battery charger outside the recommended battery
charging temperature range (see recommended
"Charging" temperature range in
and Environmental Specifications
Appendix)
Solution: Move the SF61B (and battery) and/or
battery charger to a location where they can regain
the recommended charging temperature and
charge the battery (no need to replace the battery).
What it Means
Good read - the scanner successfully scanned a bar code.
Power-up.
Temperature
in the
11