R Type; R1 Type - TOHATSU BFT 75A Owner's Manual

Hide thumbs Also See for BFT 75A:
Table of Contents

Advertisement

NORMAL: ON
ABNORMAL: OFF
OIL PRESSURE
INDICATOR
6. Check to see if the oil pressure
indicator turns ON.
If it does not turn on, stop the
engine and perform the following
inspections.
1)Check the oil level (see page 56).
2)If the oil level is normal and the
oil pressure indicator does not
turn ON, consult with an
authorized TOHATSU outboard
motor dealer.
7. Warm up the engine as follows:
Above 5°C (41°F) – run the engine
for at least 3 minutes.
Below 5°C (41°F) – run the engine
for at least 5 minutes at approx.
-1
2,000 min
(rpm).
Failure to completely warm up the
engine will result in poor engine
performance.
If the engine is not properly
warmed-up before raising the
engine speed, the warning buzzer
and overheat indicator may
activate and the engine speed will
be automatically reduced.
Before leaving the dock, check the
operation of the emergency stop
switch.
STARTING THE ENGINE
Starting the Engine (R type)

(R1 type)

EMERGENCY STOP
SWITCH
EMERGENCY STOP
SWITCH CLIP
The exhaust contains poisonous
carbon monoxide.
Do not start the engine in a poor
ventilation area such as in a boat
house.
To prevent damage to the outboard
from overheating, never run the
engine with the propeller out of
water.
STOP
EMERGENCY
STOP SWITCH
LANYARD
73

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bft 90a

Table of Contents