SECTION 206-05: Parking Brake and Actuation
REMOVAL AND INSTALLATION
Parking Brake Control
Removal
1.
CAUTION: If any component in the parking brake system requires repair or if the
rear axle housing (4010) is removed, the cable tension must be released.
Place the parking brake control (2780) in the released position.
2. Remove the console. For additional information, refer to
3. Remove the parking brake control studs.
4. NOTE: Self adjust pawl must be off to allow wind up.
Place the control handle in the fully downward position, then pull the control handle forward to
wind-up the self-adjusting mechanism.
5. Insert a steel pin through hole in the lever to the ratchet wheel, then carefully release the spring
tension onto the pin.
2003 Mustang Workshop Manual
Section 501-12
.