Ford 2003 Mustang Workshop Manual page 546

SECTION 206-03: Front Disc Brake
REMOVAL AND INSTALLATION
Pads
Removal
1. Remove brake master cylinder filler cap (2162). Check brake fluid level in brake master cylinder
reservoir (2K478). Remove fluid until brake master cylinder reservoir is half full.
2. Raise and support the vehicle. For additional information, refer to
3. Remove the wheel and tire assembly. For additional information, refer to
4. CAUTION: Install new pads if worn to or past the specified thickness above the
metal backing plate or rivets. Install pads in complete axle sets.
Inspect the pads for wear and contamination.
5. Remove the caliper bolts.
1. Hold the guide pins stationary.
2. Remove and discard the caliper bolts.
2003 Mustang Workshop Manual
Section 100-02 .
Section 204-04 .