Ford 2003 Mustang Workshop Manual page 214

SECTION 204-02: Rear Suspension
REMOVAL AND INSTALLATION
Link —Stabilizer Bar
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital
components and systems and their failure can result in major service expense. A new part with
the same part number must be installed if installation becomes necessary. If substitution is
necessary, the part must be of the same finish and property class. Torque values must be used
as specified during reassembly to make sure of correct retention of these parts.
1. Raise the vehicle on a hoist. For additional information, refer to
2. NOTE: Spring is removed for clarity.
NOTE: To remove the nuts, first loosen the nut, then use the hex holding feature to prevent the
stabilizer bar link ball joint from turning while removing the nut.
Remove the nuts and the stabilizer bar links (5C488). Discard the nuts.
Installation
1. NOTE: The nuts on the stabilizer bar links are of a torque prevailing design. New nuts must be
used during installation.
NOTE: To install the nuts, first install the nut until snug using the hex holding feature to prevent
the stabilizer bar link ball joint from turning. Final tighten the nuts using a socket and a torque
wrench.
To install, reverse the removal procedure.
2003 Mustang Workshop Manual
Section 100-02 .