Adjust The Volume Of The Instrument - GEM RP220 Owner's Manual

1. Press the LAYER button.
2. Press the DATA +/– buttons to scroll the various sounds.
In this case, pressing the DATA + button will change the sound
assigned to the layer section from Strings to Slow Strings, then to
Mellow Strings and so on, cyclically through the entire Sound data
base (see the Sound Program table on page 31 of this manual).
Clearly, if you use the DATA – button, you can scroll the sounds in
reverse order.
•

Adjust the Volume of the instrument

You can adjust the volume of the instrument as a whole by using the
Volume slider.
This control increases or decreases the volume of the internal speakers,
the Headphones and the Output Left - Right/M jacks.
• Change the Volume Balance between two sounds
If you are playing either in Layer or Split mode, you can adjust the volume
of the two sections in real time using the BALANCE buttons (in the
CONTROL section). These buttons adjust the volume of one section with
respect to the other, creating a perfect balance between the two sections
according to your requirements.
1. Press the BALANCE
sound.
A temporary display activates showing a bar graph representing the
balance level between the two sounds:
Holding the BALANCE
main sound continually and at the same time, decreases the volume
of the second sound (split or layer) proportionally.
2. Conversely, press the BALANCE
of the second sound.
10
...
button to increase the volume of the main
button down increases the volume of the
button to increase the volume
...