Table of Contents
Advertisement
• Change the Split point setting
The default setting of the Split point corresponds to F#3. You can quickly
modify the setting to suit your requirements.
1.
Press and hold down the SPLIT button.
2.
Press the note on the keyboard corresponding to the new split
point required.
In the example, the new split point is shown in the display as B3.
The setting remains memorized until you select a different Preset.
The new Split Point setting may be memorized to the Preset with the
Store button. It is possible to assign a different Split Point setting
to each Preset.
• Activate Layer mode
To mix or "layer" two sounds together, simply press the LAYER button.
1.
After pressing the LAYER button (the LED turns on), a second
sound is activated layered with the first (in this case, Strings is
added to the GrandPiano sound).
<------------------------ GrandPiano ---------------------->
<-----------------------
2.
If you press the LAYER button again, the LED turns off and the
keyboard returns to the previous mode with the GrandPiano sound
active to play across the entire keyboard.
• Change the sound assigned to a Layer
When you press the LAYER button, the display shows the sound assigned
to the layer:
If you press the LAYER button, the display returns to normal showing the
starting situation (in this case the GrandPiano display).
Strings
---------------------->
9
Advertisement
Table of Contents
