Table of Contents
Advertisement
Countdown
Press the Cursor Down button to select the Countdown parameter.
Here you can activate/deactivate the countdown measure.
When you press Play (or Pause) to start your recording after activating the
sequencer, the Countdown measure gives you a one measure lead into
the recording. No events are captured by the sequencer if you play during
the one measure countdown.
If you prefer to record without the countdown measure (ON by default),
press the DATA – button to deactivate the setting (Off).
If you record your tracks with the Countdown measure off, start playing as
soon as you press Play (or Pause).
The display deactivates automatically after about 5 seconds, but you can
close it by pressing the Tempo or Escape buttons.
The FF and REW buttons
These two buttons allow you to "move" through a sequence from measure
to measure. The REW button "rewinds" the sequence one bar at a time
and the FF button advances at the same rate.
Holding either button down scroll forwards or backwards at a faster
speed.
The REW and FF buttons can be used in the record and playback modes.
Muting the Tracks
While listening to a sequence, you can mute a Track by deactivating the
corresponding button. In Playback mode, the LED of the tracks that
contains data is shown on.
To mute a track, press the corresponding button. The LED turns off to
show the muted status.
To reactivate the Track, simply press the button again (LED on).
The Erase button
The Erase button allows you to cancel the events recorded in the
sequencer tracks.
Press the Erase button then press the button of the track you wish to
erase.
The LED of the button pressed goes off to indicate that the track is now
empty.
66
TIME SETTING
TIME SIGNATURE:
4/4
TEMPO:
120
CLICK VALUE:
100
COUNTDOWN
ON
Advertisement
Table of Contents
