Reverb Send (Rev. Send) - GEM RP220 Owner's Manual

4. Reverb Send (Rev. Send)

Press the CURSOR RIGHT button to access the Rev. Send function.
The Rev Send function can be used to independently control the amount
of reverb applied to a section (Single, Split or Layer) of the current Preset.
For example, the single Preset GrandPiano recalls a reverb send of 64 (a
moderate reverb amount), the Layer section (Strings) is programmed at
90 (to give more depth to the sound) and the Split section (Ac.Bass) plays
with a Rev Send value of 0.
Note: the following examples can be heard on your instrument only if the
Reverb button is selected (LED on).
The status of the Rev Send setting for the main sound is shown by the
negative cursor:
To apply more or less Rev Send to the currently displayed section, press
the DATA + or – buttons. You can adjust the Rev. Send value within the
range 0 ... 127. The "0" setting corresponds to no Reverb.
To modify the Layer section, press the Cursor Down button and change
the value with the Data +/– buttons.
To modify the Split section, press the Cursor Down button and change the
value with the Data +/– buttons.
Holding down the DATA + or – button increases or decreases the Rev
Send value rapidly and stops instantly after release.
Note: Remember that changes made to the Rev. Send parameter for the
Layer and/or Split sections will only be heard if the corresponding Layer
or Split buttons are active (LEDs on).
EDIT MENU
Main :
Layer :
Split :
Rev. Send Pg. 4
EDIT MENU
Main :
Layer :
Split :
Rev. Send Pg. 4
EDIT MENU
Main :
Layer :
Split :
Rev. Send Pg. 4
64
90
0
64
90
0
64
90
0
33