Effect Send (Efx. Send) - GEM RP220 Owner's Manual

5. Effect Send (EFX. Send)

Press the CURSOR RIGHT button to access the Efx. Send function.
This function works in exactly the same way as Reverb Send. The EFX.
Send function can be used to control the amount of Effect applied to the
various sections of the current Preset.
For example, the single Preset GrandPiano recalls an Effect Send of 64,
the Layer section 100 and the Split section 0.
Note: the following examples can be heard on your instrument only if the
Effect button is selected (LED on).
The status of the Efx. Send parameter for the main sound of the
GrandPiano Preset is shown as follows:
To apply more or less Efx. Send to the currently displayed section, press
the DATA + or – buttons. You can adjust the Efx. Send value within the
range 0 ... 127. The "0" setting corresponds to no Effect.
To modify the Layer section, press the Cursor Down button and change
the value with the Data +/– buttons.
To modify the Split section, press the Cursor Down button and change the
value with the Data +/– buttons.
Holding down the DATA + or – button increases or decreases the EFX.
Send value rapidly and stops instantly after release.
Note: Remember that changes made to the Efx. Send parameter for the
Layer and/or Split sections will only be heard if the corresponding Layer
or Split buttons are active (LEDs on).
34
EDIT MENU
Main :
Layer : 100
Split :
Efx. Send Pg. 5
EDIT MENU
Main :
Layer : 100
Split :
Efx. Send Pg. 5
EDIT MENU
Main :
Layer : 100
Split :
Efx. Send Pg. 5
64
0
64
0
64
0