Rear Panel - GEM RP220 Owner's Manual

Rear panel

1
1. Computer:
2. Output
Left - Right/M:
3. Input
Left - Right/M:
4. Pedal Switch:
5. MIDI interface:
4
2 3
Allows direct connection of the instrument to a PC or Macintosh computer (or
relative compatibles) without the need to use a MIDI interface.
These two outputs are used to connect the instrument to another amplifier, mixer or
recording device in stereo. If you are connecting to mono equipment (e.g. a guitar
amplifier) then you should use only the Right/Mono jack.
You can use these two inputs to connect another instrument or sound module to the
piano. The output of the other instrument will be mixed with the main signal of the
RP220 and sent to the Output, Speaker and Headphone jacks. If you are connecting
a mono signal (e.g. a microphone) then you should use only the Right/Mono jack.
The pedal group consisting of three pedals (Damper, Sostenuto and Soft) should be
connected to this connector.
These ports allow the instrument to be connected to other MIDI devices. MIDI In
allows the sounds of the RP220 to be played by an external device, e.g. a controller
keyboard or sequencer. MIDI Out sends MIDI information from the RP220 to other
equipment so that the instrument can be used as a controller. MIDI Thru provides
a copy of the information being received by the MIDI In. Use MIDI Thru when
connecting a number of different instruments together.
4 5