Xerox WorkCentre 5016 User Manual page 99

Xerox WorkCentre 5016/5020 User Guide
Downloaded From ManualsPrinter.com Manuals
Symptom
A print job is sent to the machine correctly,
but the machine does not start printing.
Failed to print on the paper in the tray that
you selected.
Damaged or deformed transparencies
Blank output
Fault Clearance Procedure
Recommendation
Make sure the application that you are
trying to send a print job from is working
properly on the computer.
Make sure that the appropriate printer
cable is used.
Make sure that the printer cable is
connected securely.
Check to see if the size of paper loaded in a
tray matches the size of paper that you
specified in the print driver.
Print data is still being transmitted. The
machine does not start printing unless it
receives the full data. If printing a graphic-
intensive document, wait for a while. Data
transmission may take a while.
Check to see if the paper size that you
have specified in the print driver matches
the size of paper that is actually loaded in
the tray.
Make sure that paper is loaded correctly in
the tray.
Transparencies can be loaded only in the
Bypass Tray.
Check that the document is loaded face up
in the Document Feeder.
Check that the document is placed face
down on the Document Glass.
If toner has recently been added to the
Drum Cartridge, it may not be dispersed
properly. Run the job again.
Check that the sealing tape has been
removed from the new Drum Cartridge.
Reinstall the Drum Cartridge.
Replace the Drum Cartridge.
Add toner if the toner indicator on the
Machine Diagram (mimic) flashes or the
error code indicating that toner needs to be
added appears in the Display.
99