9. Open the retaining clips and gently pull the memory module out of the memory slot.
Figure 69. Removing a memory module
10. Position the new memory module over the appropriate memory slot. Ensure that the notch
memory module aligns correctly with the slot key
straight down into the slot until the retaining clips close.
Figure 70. Installing a memory module
11. Reinstall the PCI Express x16 graphics card if you have removed it. See "Replacing a PCI Express
card" on page 134.
12. Position the heat sink fan duct on the top of the new heat sink and fan assembly as shown. Then, press
the heat sink fan duct straight down until it snaps into position.
122
ThinkCentre M800 and M900 Hardware Maintenance Manual
2
on the system board. Push the memory module
1
on the