Lenovo ThinkCentre M800 Hardware Maintenance Manual page 110

6. Press the retaining clip
same time.
Figure 34. Pivoting the drive bay assembly upward
7. Disconnect the thermal sensor cable from the thermal sensor connector on the system board. See
"Parts on the system board" on page 35.
8. On the inner side of the front panel, press the left retaining clip
thermal sensor as shown and then push the clip out of the outer side of the front panel. Then, disengage
the plastic holder holding the thermal sensor from the chassis.
Figure 35. Removing the thermal sensor
9. Pull the entire thermal sensor out of the chassis.
102
ThinkCentre M800 and M900 Hardware Maintenance Manual
1 in the direction as shown and pivot the drive bay assembly upward at the
1 that secures the plastic holder of the