AJA KONA 4 Installation & Operation Manual page 23

KONA v12.4
5. Visually locate the PCI-Express slots inside the Mac chassis (Mac Pro photo shown on
the following page). The KONA card only requires a x4 lane PCI-Express slot, so any of
the available slots will work correctly—(slot 3 is the preferred slot on the MacPro).
You should configure the slots with the Apple Expansion Slot Utility application for
the MacPro so that the KONA is at x4 or better speed.
6. Remove the card-edge access cover from the desired slot where you will be inserting
the KONA card. The card edge cover is secured by a tie-down bar with two secured
screws on MacPro computers; remove and set them aside for securing the KONA card
after installation.
7. Holding the KONA card by the end plate and an outside edge, carefully insert the
card by rocking it slowly into the slot. Ensure the card edge aligns properly with the
computer's slot opening (where the card edge cover was just removed) and that it is
fully seated in the slot.
8. Secure the card in the slot using the screw removed earlier or with the tie-down bar
found on MacPro machines.
9. Replace the outer access door on the MacPro.
Figure 3. KONA Card (model 3G shown)
23 www.aja.com