AJA KONA 4 Installation & Operation Manual page 18

Metadata may be input our output at a time, and can be configured in the AJA Control
Panel, which is detailed later in this manual. Transport Methods other than SMPTE 2022-6
may become available in the future.
For a list of 10GbE SFP+ modules tested by AJA, use the link below:
www.aja.com/en/products/kona-ip#techspecs
HDMI Output A full-size HDMI connector on the KONA IP endplate provides HDMI 1.4 capability.
NOTE: KONA IP supports SD and HD over HDMI.
HDMI also supports multi-channel embedded audio (8 channels). HDCP is not supported
on the output.
Reference Video A single BNC on the KONA IP endplate allows you to synchronize KONA outputs to your
house analog reference video signal (or black burst). If you have a sync generator or
central piece of video equipment to use for synchronizing other video equipment in your
studio, connect its analog composite output here. When KONA outputs video, it locks to
this reference signal. When connecting a reference video source, the locking signal
should be the same format as the Primary format selected in KONA software. It is possible
in some circumstances to use an alternate format video signal if the basic frame rate is
compatible. KONA IP can also lock to an incoming SMPTE 2022-6 signal, or it can free run.
KONA v12.4 18 www.aja.com