How To Wire Your Ceiling Fan - Emerson LURAY ECO CF860BQ00 Owner's Manual

BP7515 CF860 Luray Eco
6. Optional Installation No-Light Plate Assembly
6.4
Carefully tuck all the wires into the Light Kit Adapter.
Place the no-light plate into the opening of the Light Kit
Adapter, aligning the three flat areas on the top edge of
the no-light plate with the three raised dimples on the
Light Kit Adapter and turn the plate clockwise until it
stops (Figure 23).
NOTE: The no-light plate is equipped with an
interference device that will not allow it to be
installed if the light kit assembly is not removed.
NOTE: Periodically check that the no-light plate is
seated fully clockwise in Light Kit Adapter.
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
7.1
Connect the green grounding lead from the hanger ball
and the green grounding lead from the hanger bracket
to the grounding conductor of supply (this may be a
bare wire or wire with green colored insulation).
Securely connect wires with wire connectors (supplied)
(Figure 24).
1/4/16 2:35 PM Page 14

7. How to Wire Your Ceiling Fan

WARNING
WARNING
ROTATE
CLOCKWISE
Figure 23
GROUND
CONDUCTOR SUPPLY
LISTED WIRE
CONNECTOR
GREEN WIRE
(GROUND) FROM
HANGER BALL
GREEN WIRE
(GROUND) FROM
HANGER BRACKET
Figure 24
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal injury
or property damage.
14
(Continued)
NO-LIGHT PLATE
INTERFERENCE DEVICE
LIGHT KIT
ADAPTER
RAISED
DIMPLES (3)
NO-LIGHT PLATE
FLAT AREA OF NO-LIGHT
PLATE (3)
ETL Model No.: CF860