Advertisement
Quick Links
KX-TGA523CE_OI 04.4.28 11:32 ページ 1
1
Getting Started
1-A Accessories
(included)
Battery ..............................one
Handset Cover ..................one
Belt Clip ............................one
Charger Unit .....................one
1-C Connecting the AC Adaptor/Setting Up the Loop Antenna
3
2
1
Stand the antenna up by
inserting the tab into the slot
until it clicks into place.
•To disconnect the antenna, firmly pull the
antenna cord, holding the cord near the plug.
1-D Installing the Handset Battery
Insert the battery (#) and press it down until it snaps into the
compartment ($). Close the cover.
1
1-B Location of Controls
Handset
Ringer/Message
Alert Indicator
Antenna
Display
Soft Keys (1-G)
Headset Jack
[OFF] Button
(5-A)
[
] (TALK)
[MENU] Button
Button
Navigator Key
[
] (Speaker-
phone) Button
[REDIAL] Button
[ Y ] (TONE)
[FLASH/
Button
CALL WAIT]
Button
[ HOLD/INTERCOM]
Button
Charge Contacts
(1-F)
Note: The steps necessary to start up the
handset are described in these Operating
Instructions. Please read the KX-TG5200C/
KX-TG5202C/KX-TG5230C/KX-TG5240C/
KX-FPG391C operating instructions for
further details about the handset operations.
Loop
Antenna
2
Charger (with Clock Radio)
[SNOOZE/MUTE] Button (2-D, 4-C)
[BUZZER, ALARM SET]
Button (4-B)
[RADIO, ALARM SET]
Button (4-A)
Charge Contacts
(1-F)
CHARGE
Indicator (1-F)
[+, -, TUNE/CLOCK]
Button (1-H, 2-A)
Memory Buttons ([M1], [M2],
[M3], [M4] and [M5]) (2-B)
[SLEEP] Button (3-A)
[OFF] Button (2-A, 4-C)
[FM/AM, RADIO] Button (2-A)
Make sure the
Hook
AC adaptor plug
is securely
connected to the
unit. Feed the
cord through the
hooks as shown.
Hooks
•USE ONLY WITH Panasonic AC ADAPTOR PQLV1.
•The AC adaptor must remain connected at all times. (It is normal for
the adaptor to feel warm during use.)
1-E Belt Clip
You can hang the handset on your belt or pocket using the included
belt clip.
To attach the belt clip
VOLUME
Display
Control (2-A)
[TIME SET]
Button (1-H)
[ALARM ON/OFF]
Button (4-D)
Power Outlet
(AC 120 V, 60 Hz)
AC Adaptor
To remove the belt clip
While pressing the top of the clip
( A ), pull the right edge in the
direction of the arrow ( B ).
B
A
Getting S
Advertisement
Related Manuals for Panasonic KX-TGA523C
Summary of Contents for Panasonic KX-TGA523C
- Page 1 Stand the antenna up by inserting the tab into the slot until it clicks into place. •USE ONLY WITH Panasonic AC ADAPTOR PQLV1. •The AC adaptor must remain connected at all times. (It is normal for •To disconnect the antenna, firmly pull the the adaptor to feel warm during use.)
- Page 2 Place the handset on the charger and charge Battery information for 6 hours before initial use. Repeat After your Panasonic battery is fully charged, you can expect the charging will require approximately the same following performance: amount of charging time (6 hours) if the...
-
Page 3: Listening To The Radio
KX-TGA523CE_OI 04.4.28 11:32 ページ 3 Listening to the Radio Section 2 2-C Improving Reception Memory Buttons ([M1], [M2], [M3], [M4] and [M5]) For FM For AM [SNOOZE/MUTE] Extend the cord and place [+, -, TUNE/CLOCK] the antenna in a location Reorient the antenna horizontally [OFF] where reception improves. -
Page 4: Using The Alarms
KX-TGA523CE_OI 04.4.28 11:32 ページ 4 Using the Alarms Using the Alarms Section 4 4-B Setting the Buzzer Alarm The charger unit features an alarm clock. You can set the alarm to play the radio or to sound a buzzer at a set time. The radio alarm and the buzzer alarm can be set separately. -
Page 5: Things You Should Know
(1-H). Radio and buzzer alarm PANASONIC PRODUCT—LIMITED WARR settings (4-A, 4-B), and radio station Panasonic Canada Inc. warrants this product to be free from defects in material and workmanship and agr below from the date of original purchase. presets (2-B) will also be lost. - Page 6 87.5 – 108.0 MHz (100 kHz steps) eries are nearest you. AM: 520 – 1710 kHz (10 kHz steps) •Our Customer Care Centre at (905) 624-5505 or www.panasonic.ca •A Panasonic Factory Servicentre listed below: Frequency Response: 40 Hz – 4 kHz for FM band ±...