Table of Contents
Advertisement
Exhibit 1.4-1 iPBridge 1550D back panel
Ethernet
speed LED
Installation instructions
1
Place the iPBridge 1550D where you want it.
2
Connect SCSI devices to the iPBridge. (See
Connecting SCSI devices to the SCSI port
page 11)
3
Connect the iPBridge to your SAN: attach CAT
6 or CAT 5E cables to the Ethernet port on the
iPBridge or connect an RJ11 and adapter
crossover serial cable (null modem) between
the iPBridge serial port and one of the
computer's serial COM ports.
4
Connect the power connector and power up.
5
Boot the computers on the SAN.
Ethernet
activity LED
on
air vents
SCSI port
activity LED
6
Access iPBridge Services via the Ethernet port.
(See
Configuring the iPBridge
the serial port
(Connecting using the serial port
on page 14)
7
Verify that the bridge can be accessed on the
local Ethernet network by using the
(See
Step 7
on page 15)
8
Set up the configuration for the devices
connected to the iPBridge (See
iPBridge
on page 17.)
9
Power cycle the iPBridge. The iPBridge will
automatically map the devices on startup.
Installation: ATTO iPBridge 1550D
power
connector
Power
LED
on page 13) or
Ping
utility.
Managing the
10
Advertisement
Table of Contents
