Table of Contents
Advertisement
set ipgateway dp0 e.f.g.h
where e.f.g.h is a valid gateway.
9
To save the settings, type
saveconfiguration restart
Using Telnet
Up to three Telnet sessions can be conducted
simultaneously. Whichever session issues the first
"set" Command Line Interface command (refer to
CLI provides ASCII-based interface
page 21) can continue to issue set commands,
while the other sessions can only issue "get"
commands or display information. Once a
connection is established, refer to
commands summary
commands.
To connect using Telnet
1
Connect through the GbE port as outlined in
Connecting using the GbE port
computer on the same Ethernet network.
2
Start a Telnet session.
Note
There is more than one way to connect to the
iPBridge using a telnet program.Your telnet
program may operate differently than in the
following instructions.
3
Obtain the iPAddress for the iPBridge from your
system administrator. The default address is
10.0.0.3
15
ATTO Technology Inc. iPBridge Installation and Operation Manual
on
CLI
on page 23 for lists of valid
using a
The iPBridge will save the changes and
perform a restart.
10 Once rebooted, verify that the iPBridge can be
accessed by your network using standard
network techniques such as the ping
command.
4
At the telnet prompt, issue the open command:
telnet > open x.x.x.x
where x.x.x.x is the IP address of the iPBridge.
5
If you have to specify a port type, enter the port
type "telnet" and the terminal type "vt100".
port type:telnet
terminal type: vt100
6
Enter the default values for the username,
"root", and the password, "Password".
Note
The username is case insensitive and
password is case sensitive.
7
To verify that you have connected successfully,
type help after the Ready prompt and press
Enter.
• If a list of all available commands does not
appear on the screen, review the steps in this
section, check the cable, or contact service
personnel until the problem is solved.
• If you wish to change the default username
and password for world wide web, Telnet and
FTP use, continue with the section
change the default administrator password
on page 17.
To
Advertisement
Table of Contents
