Mapping Commands; Multitargetmode; Route; Routedisplay - ATTO Technology 1500D/E Installation And Operation Manual

You may map devices via the web-based server or through the management or serial ports.
AutoMap
Automatically assigns a subset of iSCSI LUNs to a subset
of SCSI target destination devices visible to the
iPBridge.Valid existing maps will not be deleted.
Immediate command: AutoMap
iSCSITarget
Creates/deletes an iSCSI target name. The target name
will act as a suffix to the standard bridge iSCSI-qualified
name. The target name may not exceed 24 characters. A
newly-created target has one LUN, the iPBridge LUN, at
LUN 0. If the target name already exists, this command
does nothing.

MultiTargetMode

this command. In verbose mode, overwriting a map
requires secondary confirmation of the action.
Immediate command: iSCSITarget [Target Name]
<delete>
MultiTargetMode
Enables/disables iSCSI multiple target mode addressing
on the iPBridge. If enabled, all previous maps will be
deleted. In verbose mode, overwriting a map requires
secondary confirmation of the action.
Default: disabled
Set syntax: set MultiTargetMode [enabled | disabled]
Get syntax: get MultiTargetMode

Route

Assigns a host protocol address to a target destination
device.If
MultiTargetMode
target name must be specified. If you try to map a new
SCSI BTL to the same iSCSI LUN, the new BTL
overwrites the previous map. Using the Delete identifier
removes the map from its map table. In verbose mode,
39
ATTO Technology Inc. iPBridge Installation and Operation Manual

2.2.9 Mapping commands

must be enabled to use
has been enabled, a valid
overwriting a map requires secondary confirmation of the
action.
Immediate command in single target mode:
Route iSCSI [lun] [SCSI [bb tt ll] | Delete]
Immediate command in multiple target mode:
Route iSCSI [Target Name] [lun] [SCSI [bb tt ll] | Delete]

RouteDisplay

Displays a list of iSCSI to SCSI Bus, Target, LUN
mappings. If MultiTargetMode has been enabled, the
optional parameter limits the list to the
Target Name
maps which satisfy a search for the given target name. In
either mode, the optional
list to the map which satisfies a search for the given
NumEntries: decimal number of map lines displayed
Target Name: target name
Lun : target LUN
sb: decimal SCSI bus number
st: decimal SCSI target number
sl: decimal SCSI LUN number
Immediate command, single target mode:
RouteDisplay iSCSI <lun>
Immediate command, multiple target mode:
RouteDisplay iSCSI <Target Name> <lun>

SCSIInitID

Specifies the SCSI initiator ID to be used on the specified
SCSI port. All maps coinciding with the user-specified
SCSIInitID must be set to offline and will become invalid
upon issuing this command. Choices are 0 to 15.
Default: 7
Set syntax: set SCSIInitID [sb [0-15] ]
Requires a SaveConfiguration command
Get syntax: get SCSIInitID

SCSITargets

Returns a list of SCSI devices operational on the SCSI
port.
Immediate command: SCSITargets 0
parameter will limit the
LUN
.
LUN