Modelnumber; Oemconfigfile; Productid; Vendorid - ATTO Technology 1500D/E Installation And Operation Manual

ModelNumber

Controls the iPBridge model number string to an OEM-
specific value. Displays during POST and by using the
Info CLI command. ID is padded with 0s to a maximum of
8 characters
Default:1500 or 1550
Set syntax: set ModelNumber [string]
Requires a SaveConfiguration command
Get syntax: get ModelNumber

OEMConfigFile

Reports the name of the OEM Configuration file stored in
persistent memory. If no file is present,
The file is an ASCII text file which contains all the CLI
commands that can be used to override the factory default
settings of the iPBridge. It consists of a header record and
a list of CLI commands. Each line may contain up to 128
characters and must be terminated by any of the standard
EOL combinations such as
loaded via any of the current firmware update methods
(see Updating firmware
Default: ATTO
Get syntax: get OEMConfigFile
The following table lists the CLI commands supported in the OEM configuration (*.cfg) file. Any
command which displays information is not honored in the *.cfg file, i.e., only the set version of
commands will be honored.
OEM Config file supported commands
AutoMapOnBoot
BridgeName
ColdReset
DPMTU
EthernetControl
EthernetSpeed
InquiryProductID
InquiryVendorID
IPAddress
IPDHCP
IPGateway
IPSubnetMask
iSCSIAlias
is returned.
ATTO
or . Updates may be
\r, \n, \r\n
on page 47).
iSCSIChap
iSCSIChapSecret
iSCSIPortNumber
iSCSITarget
ISNSServer
iSNSLoginControl
iqnVendorPrefixID
ModelNumber
MultiTargetMode
Password

ProductID

ReadOnlyPassword
ReadOnlyUsername
RMON
ProductID
Controls the iPBridge product ID string to an OEM-
specific value. Displays during POST and the CLI Info
command. ID is padded with 0s to a maximum of 16
characters
Default: iPBridge
Set syntax: set ProductID [string]
Requires a SaveConfiguration command
Get syntax: get ProductID

VendorID

Controls the iPBridge vender ID string to an OEM-
specific value. Displays during POST and the CLI Info
command. is padded with 0s to a maximum of 8
characters
Default: ATTO
Set syntax: set VendorID
Requires a SaveConfiguration command
Get syntax: get VendorID
Route
SCSIInitID
SCSIPortBusSpeed
SCSIPortResetOnStartup
SCSIPortSyncTransfer
SCSIPortWideTransfer
SCSITermination
SerialPortBaudRate
SerialPortEcho
SpeedWrite
SpeedWriteDefault
Username
VendorID
42
Configuration: CLI