Installation; Unpack The Packing Box; Verify Contents; Place The Ipbridge Into Your System; Install Windows Drivers - ATTO Technology iPBridge 2600 Installation And Operation Manual

If you have not already completed the instructions on the Quick Start packed with your iPBridge, use
the following instructions to install the iPBridge.

Unpack the packing box; verify contents

• The iPBridge
Note the serial number of your iPBridge,
located on the bottom of the unit, for later use:
______________________________
• Serial cable
• Power cord
• "L" brackets and screws
• CD which includes the Installation and Operation
Manual, ATTO QuickNAV and ATTO drivers

Place the iPBridge into your system

1 Place the iPBridge on a stable flat surface or
install it into a standard rack.
If installing into a rack, see Exhibit 2.0-1.
a. Attach brackets so that the front side with
the LEDs face front and the connector side
is at the back.
b. Install the iPBridge horizontally within the
rack so it does not reduce the air flow within
the rack.
2 Connect the host computer to SCSI target
devices. Refer to Cabling
Appendix.
3 Power up the SCSI devices. Proper termination
is required.
4 Connect the iPBridge Ethernet port on the host
computer to your network using at least Cat5e
cable.Refer to Cabling
Appendix.
5 Connect the AC power cord from the iPBridge
to the proper AC source outlet.
CAUTION CAUTION
The power source must be connected to a
protective earth ground and comply with
local electrical codes. Improper grounding
may result in an electrical shock or damage
to the unit.
If installing into a rack note that the power
requirements plus the power draw of the other
equipment in the rack must not overload the
supply circuit and/or wiring of the rack.
6 Turn on the power switch on the iPBridge.
5
ATTO Technology Inc. iPBridge Installation and Operation Manual

2 Installation

on page i of the
on page i of the
7 Wait up to two minutes for the iPBridge Ready
LED to light indicating the bridge has completed
its power-on self test sequence.
®
8 Windows users continue to
®
drivers; Mac users continue to
IP address.

Install Windows drivers

1 Windows automatically detects the iPBridge
and asks for the driver in the Add Hardware
wizard. Select Install from a list or specific
location.
2 Click Next.
3 Choose Don't Search,
4 Click Next.
5 Choose Have disk.
6 Specify the driver as found in the PC folder in
the setup CD. The files are in a folder based on
your operating system. Use the files directly
from the CD or copy them onto a floppy or to a
local directory on your hard drive.
7 Follow the remaining instructions to complete
the installation procedure.
8 After the driver is installed, the iPBridge is listed
in the System Devices folder.

Discover the IP address

1 From the CD supplied with your iPBridge, run
the QuickNav Utility QuickNAV-windows.exe
for Windows or QuickNAV-Mac for OS X.
2 Locate the iPBridge with the serial number
recorded earlier.
3 Highlight the serial number.
4 Click Next.
If a DHCP server is available on your network,
an address is assigned automatically by the
server. Note the assigned address:
_____________________________________
If you do not have a DHCP server, get an IP
address and subnet mask from your network
administrator, type it into the area provided, and
select Next. Note the IP address and subnet
mask here._____________________________
5 Click on Launch Browser.
Windows users continue to
Initiator for Windows; Mac users continue to
Install iSCSI Initiator for OS
Install Windows
Discover the
Install MS iSCSI
X.