Table of Contents
Advertisement
Exhibit 1.1-1 iPBridge 1500E board layout
Mounting hole
Reset
SCSI Activity
LED
pin 1
Serial port
Mounting hole
Ethernet port
Exhibit 1.1-2 iPBridge 1500E board profile and dimensions
E t h e r n e t P o r t
E t h e r n e t P o r t
. 5 3 6
. 5 3 6
. 5 3 6
. 3 4 3
. 3 4 3
. 3 4 3
. 3 3 1
. 3 3 1
. 3 3 1
. 3 3 1
. 2 7 6
. 2 7 6
. 2 7 6
. 2 7 6
Installation instructions
1
Install the iPBridge 1500E in the target device
using the mounting holes in the board. (See the
board layout diagram in Exhibit )
2
Connect SCSI devices to the iPBridge. (See
Connecting SCSI devices to the SCSI port
page 11)
3
Connect the iPBridge to your SAN: attach CAT
6 or CAT 5E cables to the Ethernet port on the
iPBridge or connect an RJ11 and adapter
crossover serial cable (null modem) between
the iPBridge serial port and one of the
computer's serial COM ports.
4
Connect the power connector and power up.
Mounting hole
SCSI port
S C S I P o r t
S C S I P o r t
L o n g B o a r d E d g e
L o n g B o a r d E d g e
S h o r t B o a r d E d g e
S h o r t B o a r d E d g e
S h o r t B o a r d E d g e
SCSI Activity
Fault LED
SCSI Activity LED
R J - 1 1 P o r t
R J - 1 1 P o r t
R J - 1 1 P o r t
R J - 1 1 P o r t
- 1 1 P o r t
- 1 1 P o r t
- 1 1 P o r t
- 1 1 P o r t
E t h e r n e t P o r t
E t h e r n e t P o r t
E t h e r n e t P o r t
5
Boot the computers on the SAN.
6
Access iPBridge Services via the Ethernet port.
(See
Configuring the iPBridge
the serial port
on
on page 14)
7
Verify that the bridge can be accessed on the
local Ethernet network by using the
(See
Step 7
8
Set up the configuration for the devices
connected to the iPBridge (See
iPBridge
on page 17.)
9
Power cycle the iPBridge. The iPBridge will
automatically map the devices on startup
Mounting hole
LED
Mounting hole
P o w e r
P o w e r
. 3 1 3
. 3 1 3
. 3 1 3
on page 13) or
(Connecting using the serial port
on page 15)
Managing the
Installation: ATTO iPBridge 1500E
4-pin
power
connector
Ping
utility.
4
Advertisement
Table of Contents
