To manually configure MultiTargetMode
1
At the CLI prompt type
set MultiTargetMode enabled
Because current mapping will be deleted, you
are asked for confirmation to change mapping.
SCSITargets
2
Type
to list the SCSI devices
connected to the SCSI port.
SCSITargets
The
command lists each device
and its corresponding SCSI address. In the
example in Exhibit 2.3-2, the first tape drive is
on SCSI Port 0 (on the IPBridge) at Target ID 4,
LUN 0.
iSCSITarget
3
The command
Target node. Type
iSCSITarget [name]
The name is a suffix appended to the standard
IPBridge iqn name. The suffix name can be up
to 24 characters.
RouteDisplay
4
Type
iSCSITarget
command.
Route
5
The
command performs the mapping.
Type
Example
Refer to Exhibit 2.3-1. A SCSI library containing
a media changer and four tapes is connected to the
IPBridge through SCSI port 0.
In single target mode, the media changer is at 0, 0,
1 (port, target and LUN) and each of the tapes is
at a different LUN.
Exhibit 2.3-2 Result of typing SCSITargets 0
;
sb
st
sl Device Type
0
0
0 MediumChanger
0
4
0 Tape
0
5
0 Tape
0
6
0 Tape
Exhibit 2.3-3 Result of typing RouteDisplay iSCSI
;Target Name
;==========================================
tape0
tape0
creates each iSCSI
to see the results of the
Vendor ID
ATTO
Lun
SB
0
Bridge
1
0
4
Route iSCSI <Target Name> <lun> SCSI <sb>
<st> <sl>
•
Target Name
Name created with the
command.
lun
•
is the iSCSI LUN the SCSI device is to
be mapped to
sb
•
is the SCSI bus/port on the iPBridge the
device is connected to
•
st
and
sl
LUN that the SCSI device is currently
configured for.
To map the first tape device listed in the
scsitargets command in Exhibit 2.3-3, type
route iscsi tape0 scsi 0 4 0
To remove mapping
1
Type:
Route iSCSI [Target Name] [lun] delete
To remove an iSCSITarget
1
Type
iSCSITarget [Target Name] delete
The iPBridge occupies iSCSI LUN 0 by default,
In multiple target mode, the media changer is
mapped differently in each node: at iSCSI LUN 3
in node 0 and at iSCSI LUN 1 in node 1.
Product ID Rev. Serial Number
DVT
3.22 U0192529
IBM ULTRIUM-TD 38D0 1110094262
IBM ULTRIUM-TD 38D0 1110122312
IBM ULTRIUM-TD 38D0 1110122344
ST
SL
0
Configuration & Management: mapping
corresponds to the Target
iSCSITarget
are the SCSI target ID and SCSI
U
U
U
46