Wcdma Rx Chain Activation For Manual Measurement - Nokia MOBILE TERMINAL Service Manual

WCDMA RX chain activation for manual measurement

Prerequisites
Make the following settings in Phoenix service software:
Setting
Phoenix Channel
Signal generator to antenna
connector
Band
Steps
1. Via Phoenix Testing menu, choose WCDMA/RX Control.
2. In the RX control window, make the following settings:
3. Click Start to activate the settings.
If the settings are changed later on (for example, change of channel) you have to click Stop and Start
again.
Note: Clicking Stop also disables TX control if it was active.
4. Set the following RF generator settings:
Page 4 –20
WCDMA2100
10700
2141.0 MHz
I
COMPANY CONFIDENTIAL
Copyright © 2008 Nokia. All rights reserved.
RF troubleshooting
WCDMA900
3012
942,4 MHz
VIII
RM-356
Issue 1