RM-247
RF troubleshooting
WCDMA RX chain activation for manual measurement/WCDMA RSSI measurement
Prerequisites
Make the following settings in Phoenix service software and in the signal generator.
Setting
Phoenix channel
Signal generator to antenna
connector
Signal generator Rf-level (CW-
signal)
Steps
1. Via Phoenix Testing menu, choose WCDMA/RX Control.
2. In the RX control window, make the following settings (adjust Channel and Band according to the table
above):
3. Click Start to activate the settings.
If the settings are changed later on (for example, change of channel) you have to click Stop and Start
again.
Note:
Clicking Stop also disables TX control if it was active.
4. From the Phoenix testing menu, select WCDMA→RX Power measurement
Issue 1
WCDMA Band I (2100)
10700
2141.0 MHz
-70 dBm
COMPANY CONFIDENTIAL
Copyright © 2008 Nokia. All rights reserved.
WCDMA Band VIII (900)
3013
942.6 MHz
-70 dBm
Page 4 –13