IBM Storwize V7000 Unified Quick Installation Manual page 72

Attention: The default service IP addresses on your new Storwize V7000 Unified
control enclosure might conflict with existing devices that are attached to the
network or with other new control enclosures that you are installing. The service
IP address 192.168.70.121 subnet mask 255.255.255.0 is preconfigured on Ethernet
port 1 of the upper canister, canister 1. The service IP address 192.168.70.122 subnet
mask 255.255.255.0 is preconfigured on Ethernet port 2 of the lower canister,
canister 2.
If you encounter that situation, change the service IP addresses on the new nodes
before connecting the Ethernet cables. For details, see Figure 39 on page 51 or see
the Storwize V7000 Unified Problem Determination Guide PDF on the DVD for further
information about setting service IP addresses using a USB flash drive.
File module to file module:
v Connect an Ethernet cable from Ethernet port 1 on the first file module to the
v Connect an Ethernet cable from Ethernet port 2 on first file module to Ethernet
v Route the Ethernet cables through the cable management arms, and secure any
File module management and public ports:
v Connect an Ethernet cable from Ethernet port 3 on the first file module to an
v Optionally, connect as many other file module Ethernet ports to network
v Repeat the previous step for the second file module.
v Route the Ethernet cables through the cable management arm, and secure any
File modules to external (host ports) network (10 GB Fibre Ethernet):
You have two 10 Gbps Fibre Ethernet ports available for host connections from
each file module. Connect your network cables to the Ethernet ports in these slots
as applicable. Refer to Figure 39 on page 51.
Step 12. Attaching the Fibre Channel cables
Attach the Fibre Channel cables from the file modules to the control enclosure.
About this task
File modules:
To attach the Fibre Channel cables, perform the following steps:
v Connect two Fibre Channel cables from the first file module to the control
52
IBM Storwize V7000 Unified: Model 2073-720 Quick Installation Guide
first Ethernet port 1 the second file module. Refer to Figure 39 on page 51 for
port locations.
Note: Ethernet cables for the internal network are provided by IBM with the file
modules.
port 2 on the second file module.
excess using the cable retention features of the rack.
Ethernet network. If using two Ethernet cables (as recommended), connect
another Ethernet network cable to Ethernet port 4. When using only one
Ethernet port, the network status is marked as degraded and an associated
warning event is listed in the health center.
switches as you require
excess using the cable retention features of the rack.
enclosure. Be sure to plug one cable into one node canister on the control