IBM Storwize V7000 Unified Quick Installation Manual page 35

Table 5. The following IP address information is required before initializing your system. Fill
in all the information needed in the Value column before proceeding with this
installation. (continued)
Field
Network gateway IP address
Storwize V7000 Unified
management IP address
File module 1 IP address
File module 2 IP address
Note: The Storwize V7000 service IP addresses are not set by the USB Initialize or
by the initial configuration done through the management GUI. Refer to "Step 24.
Next steps" on page 69 for how to set them.
Additional information must be ready before you start the initial configuration of
your system using the "Step 18. Using the management GUI to complete the initial
configuration of the system" on page 66. Refer to "Information required before
starting initial configuration of your system."
Information required before starting initial configuration of
your system
Identify the information needed to configure your system using the management
GUI.
About this task
You must enter specific information into the management GUI. The tables help you
record the key values needed before the initial set up and initial configuration.
Value Notes
The network gateway IP address for
this subnet (such as 123.123.123.1)
Management IP address for the
Storwize V7000 Unified system. This
gives access to the management GUI
and CLI running on which ever file
module is currently the active
management node (such as
123.123.123.10)
The service access IP address
assigned to file module 1 (such as
123.123.123.11)
The service access IP address
assigned to file module 2 (such as
123.123.123.12)
Chapter 1. Before you begin the installation
15