IBM Storwize V7000 Unified Quick Installation Manual page 34

v
v
v
v
v
v
v
v
v
Note: You cannot use VLAN-based subnets to configure the system network. To
configure the Storwize V7000 Unified management IP address, file module 1 and 2
IP addresses, subnet mask, and gateway address, you must provide non-VLAN
based network information. Also, all IP addresses entered must be on the same
subnet. After the system is configured, use the chnwmgt command to change the
Storwize V7000 Unified network settings to switch to a VLAN-based subnet. This
recreates the network with a VLAN-based subnet. You must also use the chsystem
-consoleip CLI command to show the Storwize V7000 the new management IP
address.
14
IBM Storwize V7000 Unified: Model 2073-720 Quick Installation Guide
E 10 Gbps Ethernet switch
F Client machine
G Client machine
H Fibre Channel switch
AA 1 Gbps Ethernet direct connection between the file modules
BB 10 Gbps Ethernet network
CC Fibre Channel network
DD 1 Gbps Ethernet
EE Fibre Channel direct connection from file modules to node canisters
Table 5. The following IP address information is required before initializing your system. Fill
in all the information needed in the Value column before proceeding with this installation.
Field
Storwize V7000 primary IP
address
Storwize V7000 secondary IP
address
Storwize V7000 node canister
1 service IP address
Storwize V7000 node canister
2 service IP address
Network subnet mask
Value Notes
Primary management IP address for
the Storwize V7000 system (such as
123.123.123.20)
Optional secondary management IP
address of the Storwize V7000 system
(such as 123.123.123.19) This is not
set by the USB initialize or through
the initial configuration wizard in the
management GUI. Refer to "Step 24.
Next steps" on page 69 to help you
configure this option later.
Optional service IP address of
canister 1 in the control enclosure
(such as 123.123.123.21) This is not
set by the USB initialize or through
the initial configuration wizard in
management GUI. Refer to "Step 24.
Next steps" on page 69 to help you
configure this option later.
Service IP address of canister 2 in the
control enclosure (such as
123.123.123.22) This is not set by the
USB initialize or through the initial
configuration wizard in management
GUI. Refer to "Step 24. Next steps"
on page 69 to help you configure this
option later.
Subnet mask for the network subnet
in which the management IP
addresses for the system will all
reside. (such as 255.255.255.0)